How To Repair Rear Blinker And Brake Light Not Working (Solved) Home > Brake Light > Rear Blinker And Brake Light Not Working

Rear Blinker And Brake Light Not Working

Contents

Questions sent by email or PM will not be answered. The fuse itself looks fine, but again I'm getting nothing when testing the fuse box. 07-08-2010, 02:29 PM #13 Midnight Tech AdministratorAutomotive Team Manager Join Date: Dec F-250 Super left rear blinker and brake light not working. Reply Page 1 of 2 1 2 Tweet LinkBack Thread Tools Display Modes post #1 of 30 Old 03-20-2011, 03:36 PM Thread Starter MVHVAC Granite Guru Join Source

Replaced the body control module and it solved my problem. importedleafsfan 2011-05-02 14:18:39 UTC #8 Thanks folks! I did the Camaro w/o doing this step and got it done, but it was difficult. Sounds like you have an Open circuit, either power in or ground out (not sure what they may share, but it's one or the other), to that drivers rear light cluster.

Brake Light And Turn Signal Not Working On One Side

Well thats not such a good idea because.......it then bounced around and the rubber cap laid against the muffler, which then melted it and grounded the white/yellow wire which is the If the signal switch checks OK, replace the signal(trailer) relay. Do the rears flash with the hazards on?

  • Also noticed that the right portion of my brake light up top is out.
  • I really appreciate all this.
  • Check the fuses as described above.

A manual is really a 'must have' in my book. If the bulb doesn't light, the bulb is bad, the socket isn't making contact, or the ground is bad. Note that passwords are case-sensitive. Brake Lights And Turn Signals Not Working F150 CONDITION C: You've lost boththe signal and brake light on one side only.

If all your flashers are good, bulbs are good, relays are good, it may be the actual blinker switch 1 out of 1 people think this is helpful. Turn Signal And Brake Light Not Working On Trailer I never had this issue until after I installed an after market receiver hitch with the pigtail for hookup. He advised to install a little bit larger fuse to make up for the loss. I check and it shows my passenger side rear blinker, tail, and stop doesn't work.

Would like to solve this before I throw another variable into the mix. Brake Light Not Working But Tail Light Works I'm losing my mind. Turn on the parking lights. What electric car is the best?

Turn Signal And Brake Light Not Working On Trailer

CarGurus has 40 nationwide Sierra listings and the tools to find you a great deal. No I am going through the same incantations with the LR indicator. (It must have been jealous from all the attention the RR indicator received.) Share Share this post on Digg Brake Light And Turn Signal Not Working On One Side Thread closed. 02-27-2013, 09:00 PM crestliner 3,188 posts, read 4,051,544 times Reputation: 1818 Quote: Originally Posted by crestliner Re check the bulbs. Rear Blinker Not Working But Bulb Is Good Loading...

Basic Wiring Primer and Troubleshooting Guide (not finished, but still very useful) ⌂HomeMailSearchNewsSportsFinanceCelebrityWeatherAnswersFlickrMobileMore⋁PoliticsMoviesMusicTVGroupsStyleBeautyTechShopping Yahoo Answers 👤 Sign in ✉ Mail ⚙ Help Account Info Help Suggestions Send Feedback Answers Home All this contact form At the rear bulb socket, unplug both the red and yellow (or green) wires from their sockets, noting their respective locations. xXTHECARGUYXx 51,488 views 14:11 Fix Yer Tail Lights! - Duration: 2:39. Use only a Signal Stat brand flasher, #180 (it comes with the kit). No Rear Brake Lights Or Turn Signals

Put it all back together and they work fine for a while. EllyEllis 2011-04-30 04:43:20 UTC #2 Well, just this week my grandaughter had brake lights but her right rear turn signal wasn't working. EDGEDiagnostic 2,055 views 4:52 Brake Light / Backup Light Troubleshooting Pt. 2 - Mystery Solved - Duration: 7:53. have a peek here if there is power up to the socket then replace the socket !

Thanks for your help! 6 following 8 answers 8 Report Abuse Are you sure you want to delete this answer? Brake Lights Dont Work But Turn Signals Do Mark helpful 0 Report kbron answered 10 months ago i have the same problem on my 2011 f350 lariet Mark helpful 10 Report InWyo answered 10 months ago Ended up taking At the rear bulb socket, unplug both the red and yellow (or green) wires from their sockets, noting their respective locations.

Push on the brake pedal (Ign.

Check out the Dynaverse! Interested in Trek gaming? Sign in to make your opinion count. Brake Lights Not Working But Bulb Is Good bulb.

Ditto on if the lights on the Other side flash as normal. Today 03:52 PM by jacktuttle -- JKOwners.com (Full - Light) ---- JKOwners.com (Full - Dark) -- JKOwners.com (Classic) -- JKOwners.com (Mobile) Contact Us |Advertise | JKowners.com : Jeep Wrangler JK If the bulb and connection are good, disconnect the pin junction to the rear harness at the left side of the dash. Check This Out Didn't think to mention it, as it seems so obvious to me.

Today 05:34 PM by Ron4x4 100 8 Attachment(s) JKO exit polling Today 05:18 PM by White13JKUR 81 78 Attachment(s) 2014 Rubicon "Throphy... I have a 08 4 door Jeep Wrangler, and for some reason my left rear brake light and turn signal are not working.. Hope this helps! Right rear, works fine the first time I use it after even just turning the ignition on.

Check all the connections to the signal switch and trailer relay. I am having the same intermittent RR blinker problem, all of my wiring is stock. The signal filament is brighter than the parking light filament, so if one light is "extra" bright the bulb may be inserted 180 degrees out in the socket, or the contact If necessary, replace either with a 15A AGC.

Did the larger fuse solve the problem? I installed my new Rock Hard rear bumper a couple weeks back, and when I removed the factory hitch I just stuck the wire harness up behind the bumper. When the stalk is set for left turn, the left brake circuit is opened and turn signal circuit closed. Adam · 3 years ago 0 Thumbs up 0 Thumbs down Comment Add a comment Submit · just now Report Abuse The genius that designed the entire light assembly put a

The blinkers have no fuses. Confession might be good for the soul, but it hurts the heart like hell. 07-08-2010, 12:47 PM #12 pspeir Registered Member Join Date: Jul 2010 Posts: 29 OS: Recalls and TSBs.